﻿## 0
You can select multiple edges. Edges can be selected as continuous, single segments or an outline of a patch.

Edges may not be continuous, but they all must be from the same solid. To detect edges between commands, press and hold Shift and move the cursor. Selection of edges cannot contain vertexes with two obtuse and one sharp edge and simultaneously vertexes with two sharp and one obtuse edge.

If one edge in a corner has a radius significantly greater than other two edges, you must round this edge first and then select and round remaining two edges together with a new edge at the end of the previously created fillet (see the examples).

It is better to set displaying of all edges (including the tangent ones). First impression could not be the best, but you can always use different settings for precise display. In the work mode and especially while filleting edges, it is always clear where the edges have their ends and if some edge is created from more segments.
## 14
Filleting, selecting edges if two edges in a vertex are sharp and one is obtuse
## 38
Filleting, selecting edges to create a rounded corner
## 43
Filleting, final state
